Replacing The Sfp Optical Transceiver; Sfp Optical Transceiver Removal And Replacement - HP storageworks director 2/140 Service Manual
Hide thumbs
Also See for storageworks director 2/140:
- Product manager manual (244 pages) ,
- Installation manual (128 pages) ,
- Release note (27 pages)
Table of Contents
Advertisement
1
Figure 75: SFP optical transceiver removal and replacement
Replacing the SFP Optical Transceiver
To replace an SFP optical transceiver:
1. Remove the transceiver from its packaging.
2. Insert the transceiver into the port receptacle, as shown in
3. Perform an external loopback test for the port
4. Reconnect the fiber optic jumper cable:
Director 2/140 Service Manual
UPM
SHR-2287
page 187). If the test fails, go to
isolate the problem.
a. Remove the protective cap from the cable connector and the protective
plug from the port's optical transceiver. Store the cap and plug in a suitable
location for safekeeping.
b. Clean the cable and port connectors
page 194).
c. Insert the keyed LC cable connector into the port's optical transceiver.
FRU Removal and Replacement
("External Loopback
"MAP 0000: Start
MAP" on page 45 to
("Clean Fiber Optic
Figure
75.
Test" on
Components" on
237
Advertisement
Table of Contents
