HP storageworks director 2/140 Service Manual page 246

FRU Removal and Replacement
8. Perform one of the following to verify AC module operation:
9. Verify that power-on self-tests (POSTs) complete and the green power LED
10. At the Hardware View, observe all FRU graphics and ensure no alert
11. Perform the data collection procedure
12. Perform one of the following to clear the system error (ERR) LED:
13. If necessary, close and lock the equipment cabinet door.
246
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate an AC module failure. If a
problem is indicated, go to
the problem.
on the front bezel, green LED on the active CTP card, and green PWR OK
LEDs on both power supplies remain illuminated. If a problem is indicated,
go to "MAP 0000: Start
symbols display that indicate a failure (yellow triangle or red diamond). If a
problem is indicated, go to
problem.
page 192).
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
— If at an EWS interface:
a. Click the Switch tab at the Operations panel. The Operations panel
displays with the Switch page open.
b. Click the Sys Err Light tab. The Switch page displays with the Sys
Err Light tab selected. A System Error Light is ON
message displays on the page.
c. Click Clear Light.
"MAP 0000: Start
MAP" on page 45 to isolate the problem.
"MAP 0000: Start
("Collecting Maintenance
"MAP 0000:
MAP" on page 45 to isolate
MAP" on page 45 to isolate the
Data" on
Director 2/140 Service Manual