Invalid Attachment Messages And Explanations - HP storageworks director 2/140 Service Manual

Repair Information
Table 23: Invalid Attachment Messages and Explanations
01 Unknown.
02 ISL connection not
allowed on this port.
176
Block Configuration—A user-configured state for the port (Blocked or
Unblocked).
LIN Alerts Configuration—A user-specified state for the port
(On or Off), configured through the Configure Ports dialog box.
FAN Configuration—A user-configured state for FAN configuration
(Enabled or Disabled).
Beaconing—User-specified for the port (On or Off). When beaconing is
enabled, a yellow triangle appears adjacent to the status field.
Link Incident—If no link incidents are recorded, None appears in the status
field. If a link incident is recorded, a summary appears describing the
incident, and a yellow triangle appears adjacent to the status field. Valid
summaries are:
— Implicit incident.
— Bit-error threshold exceeded.
— Link failure - loss of signal or loss of synchronization.
— Link failure - not-operational primitive sequence received.
— Link failure - primitive sequence time-out.
— Link failure - invalid primitive sequence received for the current link
state.
Operational State—The state of the port (Online, Offline, Beaconing,
Invalid Attachment, Link Incident, Link Reset, No Light, Not
Operational, Port Failure, Segmented E_Port, or Testing). A yellow
triangle appears adjacent to the status field if the port is in a non-standard state
that requires attention. A red and yellow diamond appears adjacent to the
status field if the port fails.
Reason—A summary appears describing the reason if the port state is
Segmented E_Port, Invalid Attachment, or Inactive. For any other port
state, the reason field is blank or N/A. Invalid Attachment Messages are
explained in Table 23.
Message
Invalid attachment reason cannot be determined.
Port is configured as an F_Port, but connected to switch
or director.
Explanation
Director 2/140 Service Manual