HP storageworks director 2/140 Service Manual page 274
Hide thumbs
Also See for storageworks director 2/140:
- Product manager manual (244 pages) ,
- Installation manual (128 pages) ,
- Release note (27 pages)
Table of Contents
Advertisement
Information and Error Messages
Table 31: HAFM Messages (Continued)
Cannot display route.
All switches in route
must be managed by
the same server.
Cannot display route.
All switches in route
must support routing.
Cannot display route.
Device is not a
member of a zone in
the active zone set.
Cannot display route
on one switch fabric.
Cannot display route.
error 9.
Cannot display route.
No active zone
enabled.
Cannot have spaces in
field.
Cannot modify a zone
set with an invalid
name. Rename zone
set and try again.
274
Message
You cannot show the
route between devices
that are attached to
switches or directors
managed by a
different HAFM
appliance.
You cannot show the
route through a fabric
that has switches or
directors which do not
support routing.
You cannot show the
route for a device that
is not a member of a
zone in the active zone
set. The source node
that you have selected
is not part of a zone in
the active zone set.
You cannot show
routes between end
devices in a fabric
when configuring
Show Routes
(Configure menu).
An internal error has
occurred while trying
to view routes.
You cannot show the
route through a fabric
with no active zone.
Spaces are not
allowed as part of the
entry for this field.
A zone set must have
a valid name to be
modified.
Description
Make sure devices named in
Show Routes dialog box are
attached to products managed
by this HAFM appliance.
The route must contain only
Edge Switch 2/16s, Edge
Switch 2/32s, Director 2/64s,
or Director 2/140s.
Enable the default zone or
activate the zone for the device
before attempting to show the
route.
Error displays when attempting
to show routes on a fabric with
only one switch. Configure
Show Routes on a multi-switch
fabric.
Contact the next level of
support to report the problem.
Enable the default zone or
activate a zone set before
attempting to show the route.
Delete spaces from the field
entry.
Assign a valid name to the
zone set, then modify the name
through the Modify Zone Set
dialog box.
Action
Error Messages
Advertisement
Table of Contents
