Installing and Configuring the Director
Configuring Fabric Parameters
Use procedures in this section to set parameters on the director for fabric
operation through the Configure Fabric Parameters dialog box. These parameters
are stored in NV-RAM on the director.
1. Verify that the director is set offline. For instructions, see
2. Choose Configure > Operating Parameters > Fabric Parameters. The
Figure 29: Configure Fabric Parameters dialog box
3. Use information under
4. After you change settings, click the Activate button.
5. Back up the configuration data when you are finished configuring the switch.
6. Set the director online. For instructions, see
Fabric Parameters
Configure the following parameters as required by your fabric.
74
Offline" on page 68.
Caution:
Setting the director offline terminates all Fibre Channel connections.
Configure Fabric Parameters dialog box displays, as shown in
parameters in this dialog box.
page 68.
"Fabric
Parameters" to change settings as required for
"Setting the Director
Figure
"Setting the Director
Director 2/140 Installation Guide
29.
Online" on