16. If necessary, close and lock the equipment cabinet door.
RRP: UPM Card
Use the following procedures to remove or replace a UPM card. A list of tools
required is provided.
Tools Required
The following tools are required to perform these procedures.
Removing the UPM Card
To remove a UPM card:
1. Notify the customer that all ports on the defective UPM card will be blocked.
2. If the director is installed in a stand-alone configuration, go to
3. Follow ESD procedures by attaching a wrist strap to the director chassis and
Director 2/140 Service Manual
— If at an EWS interface:
a. Click the Switch tab at the Operations panel. The Operations panel
displays with the Switch page open.
b. Click the Sys Err Light tab. The Switch page displays with the Sys
Err Light tab selected. A System Error Light is ON
message displays on the page.
c. Click Clear Light.
ESD grounding cable and wrist strap.
Torque tool and hex adapter (provided with the director).
fiber optic protective plugs (provided with the director).
Protective caps (provided with fiber optic jumper cables).
fiber optic cleaning kit.
Ensure the customer's system administrator quiesces Fibre Channel frame
traffic through any operational ports on the card and sets attached devices
offline.
director is rack-mounted, unlock and open the cabinet front door as directed
by the HP authorized service provider.
your wrist, as shown in
Figure
72.
FRU Removal and Replacement
step
3. If the
231