HP storageworks director 2/140 Service Manual page 127

Did removing the loopback plug solve the problem?
NO
↓
Contact the next level of support. Exit MAP.
24
A port connection timed out because of an unresponsive device (node) or an ISL
connection was not allowed because of a security violation (authorization failure
reject). Check the port status and clean the fiber optic connectors on the cable.
1. Notify the customer the port will be blocked. Ensure the customer's system
2. Block the port
3. Disconnect both ends of the fiber optic cable.
4. Clean the fiber optic connectors.
5. Reconnect the fiber optic cable.
6. Unblock the port
7. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES
↓
25
Inspect both SBAR assemblies at the rear of the director. SBAR assembly LEDs
can be inspected through the hexagonal cooling vents of the RFI shield.
Is the amber LED on an SBAR assembly illuminated but not blinking
(beaconing)?
YES
↓
Director 2/140 Service Manual
If the port is operational and a device is attached, the green LED illuminates,
the amber LED extinguishes, and the port state is Online.
YES
The director is operational. Exit MAP.
administrator quiesces Fibre Channel frame traffic through the port and sets
the attached device offline.
("Block a
page 194).
("Unblock a
NO
The Fibre Channel link and director are operational. Exit MAP.
NO
The director is operational. Go to
Port" on page 202).
("Clean Fiber Optic
Port" on page 203).
step
Components" on
27.
Diagnostics
127