Rrp: Redundant Sbar Assembly; Tools Required; Removing The Sbar Assembly - HP storageworks director 2/140 Service Manual

RRP: Redundant SBAR Assembly

Use the following procedures to remove or replace a redundant SBAR assembly
(two assemblies in the director) with the backup SBAR assembly operational. A list of
tools required is provided.

Tools Required

The following tools are required to perform these procedures.

Removing the SBAR Assembly

To remove a redundant SBAR assembly:
1. If the director is installed in a stand-alone configuration, go to
2. Follow ESD procedures by attaching a wrist strap to the director chassis and
3. Remove the RFI shield.
4. Identify the defective SBAR assembly from the amber LED on the assembly
5. The SBAR assembly is secured to the director backplane with two handles
Director 2/140 Service Manual
Standard flat-tip screwdriver.
ESD grounding cable and wrist strap.
Torque tool and hex adapter (provided with the director).
director is rack-mounted, unlock and open the cabinet rear door as directed by
the HP authorized service provider.
your wrist, as shown in
Caution: To avoid causing machine errors or damage while working on the
director, follow ESD procedures by connecting a grounding cable to the
director chassis and wearing an ESD wrist strap.
or failure information at the Hardware View.
(extractor levers) that snap lock, as shown in
Figure 73.
FRU Removal and Replacement
step
Figure 79. Open both handles.
2. If the
247