HP storageworks director 2/140 Service Manual page 62

Diagnostics
42
At the director, inspect the amber LED at the top of each CTP card.
Is the amber LED illuminated on both CTP cards?
NO
↓
43
A director-to-PC Internet link problem (Internet too busy or IP address typed
incorrectly) is indicated.
1. Wait approximately five minutes, then attempt to log in to the director again.
2. At the Netsite field (Netscape Navigator) or Address field (Internet
3. Type the username and password obtained in
Is the Embedded Web Server interface operational with the View panel
displayed?
YES
↓
44
At the View panel, inspect the Status field.
Does the director status indicate Operational?
NO
↓
45
Inspect Fibre Channel port operational states.
1. At the View panel, click the Port Properties tab. The View Port Properties
2. Inspect the Beaconing and Operational State fields.
62
YES
Failure of both CTP cards is indicated. Event codes are not recorded.
Go to "MAP 0500: FRU Failure
Explorer), type http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the IP address of the director (obtained in
The Username and Password Required dialog box displays.
View panel does not display, wait another five minutes and perform this step
again.
NO
Perform director fault isolation at the HAFM appliance. Go to
YES
The director is operational. Exit MAP.
panel displays, as shown in
Analysis" on page 107. Exit MAP.
step
Figure 15.
step
1, and click OK. If the
Director 2/140 Service Manual
1).
step 3.