HP storageworks director 2/140 Service Manual page 297

Table 32: Element Manager Messages (Continued)
Cannot run
diagnostics on a port
that is failed.
Cannot run
diagnostics on an
active E-port.
Cannot run
diagnostics on a port
that is not installed.
Cannot run
diagnostics on a port
card that is not
installed.
Cannot run
diagnostics while a
device is logged-in to
the port.
Cannot run
diagnostics while a
device is logged-in to
the port.
Cannot save IPL
configuration while
active=saved is
enabled.
Director 2/140 Service Manual
Message
Port diagnostics
(loopback tests) cannot
be performed on a
port that has failed
any previous
diagnostic (power-on
diagnostic, online
diagnostic, or
loopback test). The
amber LED associated
with the port
illuminates to indicate
the failed state.
Port diagnostics
cannot be performed
on an active E-port.
Port diagnostics
cannot be performed
on a port card that is
not installed.
Port diagnostics
(loopback tests) cannot
be performed on a
port that does not have
a small form factor
(SFF) optical
transceiver installed.
Port diagnostics
(internal loopback test)
cannot be performed
on a port while an
attached Fibre
Channel device is
logged in.
A device is logged in
to the port where a
diagnostic test is
attempted.
You cannot save the
IPL file while the
active=saved property
is set.
Description
Reset the port and perform
diagnostics again.
Run diagnostics on an E-port
only when it is not active.
Run diagnostics only on a port
that is installed.
Install a transceiver in the port
and perform diagnostics again.
Ensure the device is logged out
and perform diagnostics again.
Log out the device and run the
diagnostic test again.
The FICON Management
Server property, active=save,
must be disabled for HAFM to
save the IPL file.
Information and Error Messages
Action
297