Map 0600: Port Operational States And Actions - HP storageworks director 2/140 Service Manual

Diagnostics
46
Inspect Fibre Channel port operational states at the Embedded Web Server
interface.
1. At the View panel, click the Port Properties tab. The View panel (Port
2. Click the port number (0-127 and 132-143) for which a failure is suspected to
3. Inspect the Operational State field. Scroll down the View panel as
4.
Table 15: MAP 0600: Port Operational States and Actions
Offline
Not Operational
Port Failure
Testing
Invalid Attachment
Link Reset
Not Installed
47
Install an SFP optical transceiver in the port receptacle
Transceiver" on page 236).
1. This procedure is concurrent and can be performed while director power is on.
2. Verify location of the uninstalled port transceiver.
136
Properties tab) displays with port 0 highlighted in red.
display properties for that port.
necessary.
Table 15 lists port operational states and associated MAP 0600 steps that
describe fault isolation procedures.
Operational State
Figure 34 and Figure 35
numbers (0-127 and 132-143) for an OSI environment.
Figure 34 and Figure 35
numbers (0-127 and 132-143), and bolded logical port addresses
(hexadecimal 04 through 8F) for a FICON environment.
Go to step 16
Go to step 16
Go to step 6
Internal or external loopback test in process.
Exit MAP.
Go to step 19
Go to step 32
Go to step 47
show UPM card numbers (0 through15) and port
show UPM card numbers (0 through 15), port
Action
("RRP: SFP Optical
Director 2/140 Service Manual