Error Counter - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
M|O|U|VO|VU■□■□■ State of positioning switches (from left):
■□■ Door state door 1 to 3 (from left):
Door 1-max
Dr1 O|C|R|L □■□■ State of door signals door 1 (from left):
Dr2 O|C|R|L □■□■ See door 2
Dr3 O|C|R|L □■□■ See door 3
Load Z|H|F|O■■■□ State of load measurement (from left):
Carlight off State od car light
+24V Power on 24V power supply
O1|O2|R↓|R↑ □■□□ Temperature monitoring (from left):
Temp.[°C]
Intern

4.5 Error counter

The error counter shows the frequency of each error .
When calling the error counter menu, it shows first, since when the errors are counted (the
time of the last deletion process of the error counter).
After that, the error rate is displayed in one line and the type of error in the next line.
- Safety circuit revolving doors
- Safety circuit car doors
- Safety circuit shaft doors
(■ = Voltage present, Safety circuit closed)
- SGM (level switch)
- SGO (upper door zone switch)
- SGU (lower door zone switch)
- VO (upper pre-limit switch)
- VU (lower pre-limit switch)
(■ = switch is turned on)
(■ = Door is closed)
(□ = Door is not closed)
- Door open limit switch
- Door closed limit switch
- Reversing contact
- Light screen
(■ = input is set / Light screen is interrupted)
(? = State is unknown, e.g. if communication between HSE and FVE is
interrupted)
(- = signal not present, e.g. door without limit switches)
- Zero Load (Car empty)
- Half load
- Full load (Nominal load)
- Overload
(■ = Limit reached)
on = Power supply available
off = Battery power supply
- Overtemperature 1 (1st temperature sensor)
- Overtemperature 2 (2nd temperature sensor)
- Machine room temperature below limit
- Machine room temperature above limit
(■ = Input active – temperature limit reached)
Actual HSE board temperature (only hardwardversion 1.05)
Internal error counter
82/196