Intec MLC 8000 Operating Manual page 28

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level 3. Menu level 4. Menu level
Dr.closeD1
Dr.closeD2
Dr.closeD3
Forced Cl.
Door 1 parameter
Door type
Open park.
Revolv.door
Lightscr.[s]
Rev.open [s]
Nudging[*2s]
Opentime [s]
Closetime[s]
Open attempts
28/196
Description
autom.: The lift controller closes the door automatically when a new
call has been approached or when the parking position is to be taken.
Push: The door is only closed after operating the door-close button
Door close mode for door 2; see above
Door close mode for door 3; see above
Ignore light screen when lift is outside the door zone (yes / no)
Parameter for 1st car door
Standard: Door is controlled by digital signals
CANopen: Door drive with CANopen lift interface
allow: Lift is parked with open doors
forbid: Lift is parked with closed doors
yes: shaft doors on the door side 1 are revolving doors
time indication how long the door remains open after the reopening by
light screen interruption
time indication how long the door remains open after the reopening by
force limitation (reversing switch)
If the light screen is interrupted continuously, then the door is closed
after this time anyway (forced door closing). Here, the closing occurs
with reduced force or speed; in addition, it will sound (if available), an
acoustic signal.
Note: The nudging time is entered in 2s increments. If for example the
numerical value 20 is entered, the forced closing starts after 40s.
Entering the value 0 disables this feature.
Door opening time
This parameter has, depending on the type of door, 2 different
meanings:
- For doors with door-open-limit-switch the lift controller monitors if
the door is fully opened at the latest after this time. The time must be
chosen in this case so long, that the door has opened securely within
that time.
- For doors without door-open-limit-switch the lift controller assumes
that the door is fully opened after that time. Here, then, the time should
be entered which actually the door requires to open.
Door closing time
The lift controller monitors whether the doors are closed at the latest
after this time.
Number of door open attemps
If the door can't properly open in a floor, the lift can be operated with a