Intec MLC 8000 Operating Manual page 64

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Group conn. test
CBK test
AWG test
3. Menu level 4. Menu level
Example:
ESE2.1: UEA.1
HW:01.00SW:01.02
I1-I8:
O1-O8:
Example:
Group lifts
1......8
*-S#
Example:
CBK 1......8
Act.: CBK2
*-*
Example:
CBK2: G242C
HW:01.00SW:01.05
64/196
In the 2nd line is displayed, which ESE module is currently selected by
Pressing ENTER more details will be shown for the selected ESE (see
The status of the inputs and outputs of the selected ESE module is
displayed here (in the example ESE2.1):
1st line: Display of the module used as TSE1 (in the example general
Line 2: Display of the hardware and software version
aas-----
3rd line: status of the inputs 1-8 of ESE
aa-kkk--
4th line: status of the outputs 1-8 of ESE
Here all present HSE modules within a group are displayed (starting
from the left, lift 1 of the group ).
The example shows a group of 3 lifts:
- Lift 1: Communication to this HSE is available ('*')
- Lift 2: Communication to this HSE doesn't work ('-')
- Lift 3: The sign 'S' means that the function is carried out at lift
- The sign '#' on position 4 means that, even if the parameter "group
size" is set to 3, a fourth HSE in connected to the bus (maybe the
parameter is set wrong or the group number of lift 2 is set errornous
Module test CAN bus coupler CBK
In line 2 it is shown which CBK module is currently selected by the
Pressing ENTER the currently selected module hardware and
software version will be displayed.
1st line: Displays the board used as CBK
2nd line: hardware and software version of the CBK
Module test of the modules required for the double-AWG AWG2 and
POS2 (UEA.1 module for switching of the 2nd channel of the safety
circuit for moving with open doors)
Description
the cursor.
below).
input / output board UEA.1)
number 3
to lift number 4)
*: CBK module available
-: CBK module missing
cursor.