Intec MLC 8000 Operating Manual page 57

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Load limits
3. Menu level 4. Menu level
Up peak on [h]
Up peakoff [h]
Dn peak on [h]
Dn peakoff [h]
Up Park floor
Dn Park floor
Gr.Lift1
Gr.Lift2
...
Gr.CBK1
Gr.CBK2
...
Type
Zero [kg]
Half [kg]
Full[kg]
57/196
Description
By setting this parameter to '0', this monitoring is disabled.
Start time for upwards peak traffic (It can be set only for full hours).
Note: If start and end time have the same value, the up-peak function
is disabled.
End-time for upwards peak traffic
Start time for downwards peak traffic (It can be set only for full hours).
Note: If start and end time have the same value, the down-peak
function is disabled.
End-time for downwards peak traffic
Park floor for upwards peak traffic
Park floor for downwards peak traffic
Setting which lift working together as a group.
With this parameter it is possible to divide a group of lift into some
sub-groups temporarely without changing wiring.
See above, for lift 2
Assignment of ESE boards on branch 1 (behind bus couple unit CBK1)
to some lifts inside a group.
Together with the parameters above a larger group of lifts can be
divides in smaller sup-groups.
Parameters for load measurement
Type of load measurement unit:
Digit.input.: There are freely programmable controller inputs for load
measurement used (load measuring system with digital outputs
required)
Analog inp.: An analog load sensor is used, which is connected to the
FVE on the load measuring input
CANopen: Load measuring system with CANopen Lift interface
Below this value is detected as zero load (empty cabin)
By setting this value to 0, the no-load detection is disabled.
This value is recognized as half load (Car weight equal counterweight).
By setting this value to 0, the half-load detection is disabled
This value is recognized as full load (cabin occupied).
By setting this value to 0, the full load detection is disabled.