Intec MLC 8000 Operating Manual page 42

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level 3. Menu level 4. Menu level
Hazard car
Dr.op.call
Dr.input
Clear calls
->normal[s]
Deadman control
Deadman cont.
Lock input
Clear/En.off
Ramp drive
Ramp size
Remote off
Floor
42/196
Description
Switch: The Dangerous mode is switched on and off by a switch inside
the car
Push: Pressing the button inside the car the hazard mode is activated;
by pressing the push again it is deactivated.
autom.: After reaching the target floor by a hazard call, the hazard
mode starts automatically . If the hazard call for the current floor with
the door open is pressed again, the hazard mode is terminated (Note:
Function can be used only if it is accompanied with a separate button
for open door / close door (see below)
Indicates whether the car door opens automatically after entering the
destination floor by a hazardous call.
yes: Lift has separate push for opening / closing the door
no: Opening / Closing is started by hazardous call button
yes: If a hazardous call was set all calls are cleared and disabled
immediately.
no: All saved car calls are handled, but new calls are not accepted. If
all old car calls are handled, the lift will go to the hazardous call floor.
Landing calls are always deleted immediately.
Specifies the time after which the lift goes back to normal operation if
the lift was called by a hazardous call to a floor, but the hazardous
mode was not started via the switch or button inside the car (see
above).
Parameter for Push control (also called "Deadman control")
If set to "yes"the lift is working as a "dead-man control", ie, the lift is
only moving as long special "dead man buttons" are pressed.
Yes: Dead man function remains activated until reaching the target
floor, even if the "Dead man On" input has been turned off.
Yes: All calls are cleared if the input "Deadman" - "
Parameter for ramp drive according to EN81 (for example for loading
and unloading trucks by moving the car by open doors up to the
height of thecargo area of the truck.
Max. travel height with open doors in ramp drive mode
Parameter for Remote shutdown (Remote off)
The remote shutdown takes place in two stages. At the beginning
thelift moves to the floor attached to the "Remote off" input. Then the
floor which has been set here can also be approached
Final destination floor for Remote off function