Intec MLC 8000 Operating Manual page 55

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Energy savings
3. Menu level
SMS Number 2
SMS Number 3
Fax Alarm
Fax Number 1
Fax Number 2
PC Alarm
PC Nummer 1
PC Number 2
D-Sub connector
Drive off[s]
4. Menu level
No.
Text
...
...
Send Fax
No.
Text
...
In case of failure , a message can be sent to up to 2 different PCs (on
Send Message
No.
Text
...
...
If the lift is in floor level without call for this time period, then the drive
can be set via the special output "Drive off" in standby mode (the drive
- mainly VVVF - of course, must have a corresponding standby input
55/196
Description
Telephone number of receiver
Additional SMS text (next to lift number and error text)
Parameters for 2nd SMS number
See above
Parameters for 3rd SMS number
See above
in case of failure , a telefax can be sent to up to 2 different phone
numbers
Parameters for 1st telefax number
Activate 1st telefax number
Telephone number of receiver
Additional telefax text (next to lift number and error text)
Parameters for 2nd telefax number
See above
the PC the INTEC monitoring software IMS must be running)
Parameters for 1st PC
Activate 1st PC message
Telephone number of 1st PC
Additional alarm text (next to lift number and error text)
Parameters for 2nd PC
See above
Parameters for D-Sub connector (RS232)
See above (onboeard modules)
Parameters for energy saving
feature).
In standby mode, the lift controller ignores the drive fault signal.
If the parameter is set to 0, then the function is disabled.