Intec MLC 8000 Operating Manual page 68

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Here the actual
door state is
displayed (see
also description
of "State
display 3" in
annex)
Set car calls
Actual floor
Call floor
Call entered
Calls disabled
Technical check
Limitswitch top
Limitswitch bot.
Trip time
Speed limit
Safety gear
Mechanical brake
3. Menu level
3
5
Overspeed trip
Speed check
Brake not open
Start upwards
Start downwards
Brake off trip
68/196
4. Menu level
The doors may be controlled with the following keys::
3: Forced closing of door 1 (light screen is ignored)
6: Forced closing of door 2 (light screen is ignored)
9: Forced closing of door 3 (light screen is ignored)
↑
oder
3rd line: After pressing ENTER , for a few seconds a message is
th
4
Menu for technical inspection of the lift , according to EN-81
Test, if lift controller switches off on overspeed by starting the lift with
1,5 times of nominal speed (only possible by CANopen-lift drives)
Test, if lift controller switches off on overspeed by internal lowering
Test of the safety gear (only possible if the lift controller is equipped
with an output for remote tripping of overspeed governor)
Description
1: Open door 1
2: Close door 1
4: Open door 2
5: Close door 2
7: Open door 3
8: Close door 3
0: Stop all door movements immediately
↓
: Toggle between display of door 1/2 and door 3
Set car calls by keypad
1st line: Display of the current floor
nd
2 line: Entering the floor for the new call
shown, that the call was placed.
line: This display appears if calls are disabled.
See also chapter "Technical check"
Checking of the upper final limit switch
Checking of the lower final limit switch
Trip time test
Overspeed test
the nominal speed setting
Test of mechanical motor brake
Start without opening the brake
Start in upward direction
Start in downward direction
Switching off the brake while driving