Door Commands By Keypad; Door Commands By Inspection Switches - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Check error stack for more informations about the error.

5.2 Door commands by keypad

Using the keypad of the HSE or the handheld terminal door commands may be set and at
the same time the reaction of the door can be tested (door switch, light barrier, reversing
contact, etc.).
Door commands can be given only if the lift is at standstill.
While the menu "door commands" is active, all other movements (also emergency recall
operation and inspection control) are disabled.
After starting the menu "Door commands" the same state image 2 appears (Door state) as
described in chapter "State displays".
The following commands can be set by short pressing the corresponding button:
'1': Open car door 1
'2': Close car door 1 (Light screen is active)
'3': Close car door 1 (Light screen is deactivated - "Nudging")
'4': Open car door 2
'5': Close car door 2 (Light screen is active)
'6': Close car door 2 (Light screen is deactivated - "Nudging")
'7': Open car door 3
'8': Close car door 3 (Light screen is active)
'9': Close car door 3 (Light screen is deactivated - "Nudging")
'0': Stop all doors immediately
In lifts with manually operated revolving landing doors, the car doors can be closed
with keyboard commands only when the revolving landing door is closed and thus the
safety circuit input SK2 of HSE is set.

5.3 Door commands by inspection switches

By simultaneously pressing the inspection up and down push for at least 5 seconds (while
inspection is switched on), the controller starts the door test mode.
In this mode, the car doors can be opened by pressing the inspection up-button and closed
by operating the inspection down-button. When releasing the button, the door movement will
be stopped immediately.
By turning off the inspection switch the door test mode is terminated.
110/196