Intec MLC 8000 Operating Manual page 43

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level 3. Menu level 4. Menu level
Doors
Carlight off
Clear calls
Lift off-doors
Floor 1
Floor 2
...
Safety Beam
Safety beam
Clear CC
Saf.Reset LC
Saf.beam SL
Safety Shelter
Bearer ↑
43/196
Description
Setting the car doors which should remain open after the lift is remote
switched off.
yes: In Remote shutdown the car light is switched off, even if not all
car doors are closed.
no: Car light will stay on in Remote shutdown mode
yes: If the remote shutdown input is activated all calls are cleared and
disabled immediately.
no: If the Remote off function is activated, all saved calls are still
handled, but new calls are not accepted. If all old calls are handled, the
lift will be switched off.
Specifies the doors which shall remain open in each floor when the lift
has been turned off by the special function "Lift off" (see section Input
Functions)
Doors which will remain open after the lift was turned off on the 1st
floor
Doors which will remain open after the lift was turned off on the 2nd
floor
...
Parameter for Safety beam
Safety beam available (yes/no)
Clear all car calls if safety beam is interrupted while lift is moving
(yes/no)
Resetting the safety beam with landing possible call (yes / no)
Safety beam connected in the safety line (during safety circuit
interruption error "light beam" is indicated).
Sicherheitslichtgitter im Sicherheitskreis (bei Unterbrechung
Singcherheitskreis erscheint Fehler „Lichtgitter"
Parameter for safety shelter monitoring
Bearer type for safety shelter in shaft top:
No: No bearer necessary / available
manual: hand operated bearer
always: The bearer is always switched on in normal operation and
only switched off when the top shelter space is opened (e.g. by
opening shaft door in top floor) or the inspection control is switched
on.
moving: The bearer is switched on while the lift is moving (but not if