Intec MLC 8000 Operating Manual page 91

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Nr. Error message
53/0 Battery defect
53/1 Battery warning
66/0
PCB temp.
67/0 Motor overtemp.1
67/1 Motor overtemp.1
67/2
Room temp.
Room temp. ↓
67/3
↓
67/4
HSE-Temp.
↑
67/5
HSE-Temp.
80/1 Wrong code
nach EN81-20
Measured battery power below
7V or by 3 consecutive
measurements (normally
measured every 24 hours)
always below programmed limit
(see parameter "Batt.[mV]" in
"Internal parameter")
Measured battery power below
programmed limit (see
parameter "Batt.[mV]" in
"Internal parameter")
↑
PCB too hot
Motor overtemperature (Input
"Overtemp. 1" activated).
The operating temperature
depends on the characteristic
of the PTC thermistor.
Motor overtemperature (Input
"Overtemp. 2" activated).
The operating temperature
depends on the characteristic
of the PTC thermistor.
↑
Machine room temperature is
above limit (input
"Roomtemp.max" activated).
Machine room temperature is
below limit (input
"Roomtemp.min" activated).
HSE temperature too low
HSE temperature too high
A module with an invalid
hardware encoding (security
91/196
Description Lift controller reaction
for door zone bypassing is
activated for a short time, so that
safety circuit input SL4 will be
activated. If not this error message
is set.
Reason may be an error in wiring
or a defective safety unit.
If this error message occurs the
4th. time the lift goes out of
operation.
Back to normal operation by lift
controller reset.
Lift goeas out of operation.
After replacing the battery a
"Battery check" must be executed
or the lift must be resetted.
Battery may be defective or
discharged.
Lift still in operation (see above).
Rope lift: Stop in next possible
floor.
Hydraulic lift: Lift goes to lowest
floor; Re-levelling function still
active.
After cooling down (deactivation of
the input) return to normal
operation.
See above
See above
See above
See above
See above
Module with the invalid hardware
code is ignored by the system