Intec MLC 8000 Operating Manual page 27

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Door park mode
Door parameter
3. Menu level 4. Menu level
Fire evac. run
1.Floor
2.Floor
...
Firemen run
1.Floor
2.Floor
...
Hazard transport
1.Floor
2.Floor
...
1.Floor
2.Floor
...
Gener.door para.
Cl.push
Op.push D1
Op.push D2
Op.push D3
27/196
Description
Released doors in case of fire detection
Released doors in 1st floor
"
"
Released doors for fireman trip
Released doors in 1st floor
"
"
Released doors for hazard transportation mode
Released doors in 1st floor
"
"
If parking with open doors is enabled (see Door parameters), then here
it can be set individually for each floor, which doors should remain
open when the lift is on the equivalent floor.
Opened doors if lift is on 1st floor
Opened doors if lift is on 2nd floor
...
Parameters for up to 3 car doors
Operation of the door-close button
No delay: the door-close button is immediately active at the beginning
of the door opening, ie, the opening of the door can be interrupted by
pressing the door-close button and the door closes immediately
delayed.: button is not active until the door was fully open
Operation of the door-open button for car door 1
all: open all the doors of the relevant floor.
last: The last opened doors will open again
enabled: All released doors according to the operation mode will be
opened (see parameter "Door releases" above)
Operation of the door-open button for car door 2 (see above)
Operation of the door-open button for car door 3 (see above)