Intec MLC 8000 Operating Manual page 160

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
X1
Position Function
XHJ1 Jumper CAN bus terminator CAN1 (control bus)
→ Jumper must be set if HSE is located at the end of the CAN bus cable (control bus).
XHJ11 Jumper CAN bus terminator CAN2 (shaft bus)
→ Jumper must be set if HSE is located at the end of the CAN bus cable (shaft bus).
XHJ2 Setting for encoder type connected to HSE:
XHJ3 - 5V...12V Encoder signals: Set both jumpers
- 24V (15...30V) Encoder signals: Remove both jumpers
XHJ10 Jumper for Software download (Boot mode). Remove jumper for normal operation.
XHJ4 Setting the power supply mode for UEA board connected to slot 3 (XHJ18):
-
-
XHJ7 Setting the power supply mode for UEA board connected to slot 4 (XHJ17):
-
-
XHJ5 Selecting the CAN bus for UEA board connected to slot 3 (XHJ18):
XHJ6 -
-
XHJ8 Selecting the CAN bus for UEA board connected to slot 4 (XHJ17):
XHJ9 -
-
XHJ13 Jumper set to the top: HSE is supplied by battery power (continue working if power supply
is off)
X1 Jumper for selecting USB interface (jumper to the left) or RS232 interface (jumper to the
right (only hardware version 1.5)
BT1 Battery for real time clock RTC of HSE
HSE Hardware-Version 1.3
HSE Hardware-Version 1.5
Jumper set to the left: normal 24V power supply
Jumper set to the right: battery buffered 24V power supply
Jumper set to the left: normal 24V power supply
Jumper set to the right: battery buffered 24V power supply
Both Jumpers set to the left: UEA is connected to shaft bus (CAN2)
Both Jumpers set to the right: UEA is connected to control bus (CAN1)
Both Jumpers set to the left: UEA is connected to shaft bus (CAN2)
Both Jumpers set to the right: UEA is connected to control bus (CAN1)
I67