Intec MLC 8000 Operating Manual page 63

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
TSE test
ESE test
3. Menu level 4. Menu level
FVE : 01.10
PSE : ---
Example:
HW:01.01SW:01.01
---l-----ozs----
yIuDft---ppl
cc--ljl-k---k---
Example:
TSE 1...16
Act.: TSE 2
**-*+
Example:
TSE2: PMA.1
HW:01.00SW:01.02
I1-I8:
O1-O8:
Example:
ESE 1.1 ... 32.1
Act.: ESE 2.1
**-*+***********
***++--**
63/196
The status of the inputs and outputs of the selected control module is
displayed (in the example, the FVE):
1st line: Display of the hardware and software version
2nd line: state of the inputs 1-16 FVE
3rd line: status of the inputs 17-28 FVE
4th line: state of the outputs 1-16 FVE
The display may vary depending on the selected module.
Module test of the car panel unit TSE
Here the status of the communication is displayed of each TSE
module (starting from the left with TSE1):
+: TSE available; but should not be present according to parameter
In the 2nd line is displayed, which TSE module is currently selected by
Pressing ENTER more details will be shown for the selected TSE (see
The status of the inputs and outputs of the selected TSE module is
displayed here (in the example TSE2):
1st line: Display of the module used as TSE2 (in the example car
Line 2: Display of the hardware and software version
iiiiiios
3rd line: status of the inputs 1-8 of TSE
iiiiii--
4th line: status of the outputs 1-8 of TSE
Module test of the landing panel unit ESE
Here the status of the communication is displayed of each ESE
module (starting from the left with ESE1.1; if more than 32 ESE
modules are available they will be displayed in next picture by
scrolling with the cursor keys):
+: ESE available; but should not be present according to parameter
Description
*: TSE module present
-: TSE module missing
setting
the cursor.
below).
position indicator PMA.1)
*: ESE module present
-: ESE module missing
setting