Intec MLC 8000 Operating Manual page 128

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
- Up
- Down
- Up+Dn
Enable LC Dir.:
- Up
- Down
- Up+Dn
Visit.call 1 Callfloor
Vis.call2 up Callfloor
Vis.call2 dn Callfloor
Visit.call 3 Callfloor
Targ.call up Callfloor
Floor Doors
Floor Doors
Targetfloor Doors in
Call- and
Target floor
Targetfloor Doors in
Call- and
Target floor
Targetfloor Doors in
Call- and
Target floor
Targetfloor Doors in
Call- and
Target floor
Targetfloor Doors in
Call- and
Target floor
128/196
Description
Input to enable landing calls for specified floor and doors.
If this input is activated first the landing call for the specified "call floor" and "call
doors"is enabled for some seconds. If inside this time the landing call is
pressed, the lift will go to this floor. If the lift arrives the call floor the car call for
the specified target florr is enabled for some seconds.
See also "Special param." - "Visitor calls".
Note: On the sub parameter "Doors", both the doors for the landing call as well
as for the car call are set (doors for landing call displayed on the right side;
doors for car call displayed on the left side).
To set doors for the landing calls the keys 1, 2 and 3 are used, while keys 5, 6, 7
are used to set the doors for the car call. To clear a door press same key again.
If this input is activated first a landing call in up direction is set to the call floor. If
the lift reaches the call floor, the car call to the target floor is enabled for some
time ( „Special param. – Visitor calls").
See above how to set the doors for call floor and target floor.
See above; landing call in down direction is set.
If this input is activated first the landing call to the call floor is enabled for a
certain time (see „Special param. – Visitor calls"). If inside this time the landing
call is pressed the lift goes to this call floor. Once the call floor is reached the lift
controller automatically sets a car call to the target floor.
See above how to set the doors for call floor and target floor.
If this input is activated first a landing call in up direction is set to the call floor. If
the lift reaches the call floor, the lift controller automatically sets a car call to the
target floor.
See above how to set the doors for call floor and target floor.