Intec MLC 8000 Operating Manual page 74

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Emerg.rescue
Governor
Contactor
Brake/valve
Battery check
Reset HSE
Change password
User password
Superv.password
Remote password
Virtual Terminal
3. Menu level 4. Menu level
Example:
Voltage
Code
Code
Code
74/196
Menu item to deactivate several supervision functions of the lift
controller in case of error for emergency rescue.
In rescue mode the lift can be moved by Emergency recall operation or
In main state display "Rescue" is shown, if any of the supervision
functions is deactivated.
A supervision is deactivated by setting its value to "Off".
All settings are only stored in RAM, so all supervisions are activated
Deactivate governor supervision
Deactivate contactor supervision
Deactivate brake supervision (rope lift) or valve supervision (hydraulik
Manual start of a battery test.
Note: The battery test is also performed automatically at the set time
interval (default is 24 hours).
12850 mV
Beginning with software version 1.38b this menu item is located dir in
the technical check menu.
Perform a software reset of the HSE.
Password protection of the lift controller
Password protection for the entire menu structure; however, through
short commands it is still possible to set car calls and start the menu
Change the password (code number; max 10 numbers)
Password protection for changing parameters
Change the password (code number; max 10 numbers)
Password protection for access by remote data transmission (modem,
Change the password (code number; max 10 numbers)
Access to the operating panel of devices according to CANopen lift
Some additional keypad inputs, depending of the used CANopen lift
component, are possible:
ENTER for at least 1 second: F1 or info button (e.g. Zetadyn)
ESC for at least 1 second: stops the virtual terminal (Quit)
Description
demonstration)
by Inspection mode.
after reset or power on.
lift)
"Technical check".
Internet)
DSP417