Intec MLC 8000 Operating Manual page 138

Lift controller
Table of Contents

Advertisement

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function
Sub function/
Direction/
Floor
Standstill
Callconf.mode
Clock run 1
Clock run 2
Clock run 3
Clock run 4
Clock run 5
Clock run
Handic.LC
Handic.CC
CAN-AWG
Zone Reset
Safety circ.
Door op.ind.
Parking trip
Parking
Emerg.stop
Carlight off
Alarm enabl.
Floor
Doors
Floor
-
Signal no.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Signal no.
-
-
Doors
-
-
-
-
-
-
-
-
-
-
138/196
Description
Output is set if the lift is in a floor level and the drive is switched
off.
Output to display the actual call configuration (see „General
Param." - "Call config.")
"Signal no." = actual call configuration number
Output is set if Clock run 1 is activated.
Output is set if Clock run 2 is activated.
Output is set if Clock run 3 is activated.
Output is set if Clock run 4 is activated.
Output is set if Clock run 5 is activated.
Output is set if at least 1 Clock run is activated.
Landing call for handicapt people activated.
See also "Special param. - Handicapt people")
Car call for handicapt people activated.
See also "Special param. - Handicapt people")
If using the "Double AWG" for positioning the 2. AWG is connected
by a separate CAN bus. With this output function (and a relay
connected to this output) it is possible to connect this CAN bus
temporarely to the CAN bus A (Control bus) of the lift controller (for
configuration, teach in, diagnosis).
Output to switch off the SGM signal for a short time in order to set
the safety unit for moving with open doors in right state.
This may be necessary e.g. after a software reset of HSE or after
HSE was powered in battery mode.
Output is set if the corresponding point of the safety circuit is
closed (=Signal no.) geschlossen ist
Output is set if the corresponding door is completely opened.
Output is set during a parking trip.
Output is set if lift is parked in the parking floor.
Output is set if input"Em.stop" is activated.
Output is set if the car light is on.
Output to prevent emergency call misuse.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents