Intec MLC 8000 Operating Manual page 179

INTEC GmbH
22/12/2016
4 CAN-
XP2 1 0(24V)
2 D1
3 D2
4 D3
5 D4
6 D5
7 D6
8 D7
9 D8
10 +24V
XP3 1 D1
2 D2
3 D3
4 D4
5 D5
6 D6
7 D7
8 D8
9 0(24V)
10 +24V
XP4 Connector for Software download
XJ1 Jumper for setting of node ID:
Jumper set to the top (PCB edge): Normal operation
Jumper set to the bottom: Initialization mode (setting of node ID)
XJ2 Jumper for CAN bus terminator
→ Jumper must be set if PMA is located at the end of the CAN bus cable.
XJ3 Jumper for orientation of PMA: horizontal (Jumper not set) or vertical (Jumper set)
LED LED "Software is running"
Technical specifications:
Temperature range:
Current in idle mode:
Max. input current D1-8:
Max. output current D1-8 (PMA.1):
Max. output current D1-8 (PMA.2):
Mechanical dimensions:
Lift controller MLC 8000
Operating manual V2.0
CAN-Bus – Low signal
0V Power supply for inputs / outputs
8 inputs / outputs E1-E8 and A1-A8, low active, free programmable.
Connector XP2 is in parallel to XP3 (same inputs/outputs)
+24V Power supply for inputs / outputs
8 inputs / outputs E1-E8 and A1-A8, low active, free programmable.
Connector XP3 is in parallel to XP2 (same inputs/outputs)
0V Power supply for inputs / outputs
+24V Power supply for inputs / outputs
0°C to +60°C
ca. 35mA @ 25°C
10mA @ 25°C / Input
500mA @ 25°C / Output
350mA @ 25°C / Output
Length:
Width:
Height:
Display module: 3 Modules a 39*23mm
69mm
62mm
ca. 30mm (without connector)