Intec MLC 8000 Operating Manual page 142

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
Vis.request Callfloor
Hazard.call Floor
Level displ. Type:
- 1 of n
- Binary
- Graycode
- 7-Segm.
- 9-Seg.K
Hall lantern Dir.
Dir.arrow Dir.
Mov.arrow Dir.
Gong Dir.
Speech Direction up
Floor Doors
- Doors
Doors
Signal no. Offset
Floor Doors
- -
Floor Doors
- -
142/196
Description
Acknowledgement output for visitor request..
For more detailled description refer to "Special param. - Visitor
floors" in chapter "menu structure"
Hazard call acknowledgement(see input functions)
Outputs for controlling a conventional car level indicator (1-of-n-
coded, binary coded or Gray code). With 1-of-n setting the output is
set according to the setting "Signal no" in each floor.
For binary or gray code the signal number corresponds to the
relevant binary digit within the binary or Gray code.
Via the parameter "Offset" it can be selected, which binary or Gray
code value is output in which floor. When set to '1' the binary or
Gray code value 1 is set in the 1st floor, in floor 2 the value 2, etc.
When set to '0' the binary or Gray code value 0 is set in the 1st floor
(that means all outputs off), etc.
The assignment of the "Signal no." for a 7- or 9-segment display is
shown in the picture. For this type of displays it can be adjusted via
the "offset" if the units digit (= 1) or ten's digit (= 2) is to be
controlled.
The hall lantern output is used for signaling that the lift reaches a
floor. The signal is activated if the lift slows down for arrival.
Always the direction of the next handled call is displayed. The
signal is deactivated if the doors are closed again.
If no further call exists the hall lanterns for both directions are
displayed.
The settings "Dir.", "Floor" and "Doors" can be omitted optional;
then the output is valid for all directions / Floors / Doors.
If the lift is moving the direction arrow for the travel direction is set,
while in standstill the direction to the next call is displayed.
While moving the arrows light up continuously; in standstill state
the arrows are flashing every second.
Moving arrows always show the actual travel direction.
Output to control a gong.
More settings see „Special param." - „Gong"
Signal for speech unit for next travel direction upwards (set by