Intec MLC 8000 Operating Manual page 5

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
CDU Car Distribution Unit
CPA CAN Positioning Adapter
DCU Drive Control Unit
DSE Diagnose- und
Serviceeinheit
ESE Etagensteuereinheit
FVE Fahrkorb- Verteilereinheit
HHT Hand-Held Terminal
HSE Hauptsteuereinheit
LCI16 Liquid Crystal Indicator
LCM Lower Correction Magnet
LCU Landing Control Unit
LPLS Lower Prelimit Switch
segments
see FVE; Designation is used only when using the
main board MCU
see PSE; Designation is used only when using
the main board MCU
see ASE; Designation is used only when using
the main board MCU
Mobile handheld terminal for diagnostics and
service
Name of a control assembly which is connected
on shaft bus (CAN bus) for connection of landing
calls, special items / outputs or serves as a car
position indicator.
As ESE different modules can be used
- UEA
- LCI16
- MS3-C
- PMA
- LCD-047
- LCD-057
Car unit (usually on the car roof or in the car
operating panel)
see DSE; Designation is used only when using
the main board MCU
Main assembly of the lift controller; usually
installed in the control cabinet
LCD Module with CAN-Bus connection and 8
inputs / outputs (can be used in the cabin or
outside the panel)
Switching point (magnet) of the lower pre-limit
switch LPLS; Designation is used only when
using the main board MCU
see ESE; Designation is used only when using
the main board MCU
see VU; Designation is used only when using the
main board MCU
5/196