Table Of Contents - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Inhalt
0. Preliminary ............................................................................................................ 10
1. Introduction ........................................................................................................... 11
1.1 Operation of the Lift Controller MLC 8000 and Parameter Input ..................................11
1.2 Keyboard commands .................................................................................................12
1.3 Password protection (Code) ........................................................................................14
1.3.1 Menu code ............................................................................................................14
1.3.2 Parameter code ....................................................................................................14
1.3.3 Exceptions ............................................................................................................14
1.4 Hardware encoding .....................................................................................................15
2. Menu structure ...................................................................................................... 16
3. Commisioning ....................................................................................................... 76
3.1 Setup Mode .................................................................................................................76
3.2 Testing of individual input and output functions ...........................................................76
3.3 Setup of car doors .......................................................................................................76
3.4 Teach-in ......................................................................................................................76
3.4.1 Starting normal operation for lifts with magnetic switch positioning .......................76
3.4.2 Teach-in procedure by lifts with incremental encoder ............................................77
3.4.3 Teach-in procedure by lifts with absolute encoder .................................................77
3.5 Flush correction ...........................................................................................................78
3.5.1 Flush correction by car operation panel COP ........................................................78
3.5.1 Flush correction by keypad of HSE or handheld terminal DSE ..............................79
4. Error diagnosis ..................................................................................................... 79
4.1 General procedure for troubleshooting ........................................................................79
4.2 LED indicators .............................................................................................................79
4.3 Initial troubleshooting using state display 1 .................................................................80
4.4 Error stack ...................................................................................................................80
4.5 Error counter ...............................................................................................................82
4.6 Behavior of the controller in case of error ....................................................................83
4.7 Internal error counter ...................................................................................................83
4.8 Error warning ...............................................................................................................83
4.9 Hardware test of the individual controller boards .........................................................84
4.10 Troubleshooting at CAN bus faults ............................................................................85
4.11 Apparent errors by anti misuse detection or special functions ...................................87
4.12 Troubleshooting at the interface to external components...........................................87
4.13 Fault output ...............................................................................................................88
4.14 Error messages .........................................................................................................89
4.15 Error messages during teach-in procedure .............................................................. 107
5. Travel commands and Door commands via keypad (HSE or handheld terminal) 109
5.1 Travel commands ...................................................................................................... 109
5.2 Door commands by keypad ....................................................................................... 110
5.3 Door commands by inspection switches .................................................................... 110
6. Test of the safety functions of the lift control (Technical inspection) ................... 111
6.1. Automated Test ........................................................................................................ 111
6.1.1 Testing the safety circuit for moving with open doors .......................................... 111
6.1.2 Testing the trip time monitoring ........................................................................... 112
6.1.3 Testing the final limit switches ............................................................................. 112
6.1.4 Overspeed .......................................................................................................... 113
6.1.5 Testing the safety gear ........................................................................................ 113
6.1.6 Testing the motor brake ...................................................................................... 114
8/196