Appendix 1.6 Module Pma - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
- PIC18 microcontroller with internal Flash (32kByte), RAM (1536 Byte) and EEPROM (256 Byte)
- integrated CAN controller
- CAN interface with high-speed driver according to ISO11898 with galvanic isolation (Hardware
version 2.1) or without galvanic isolation (Hardware version 1.1)
- ICSP interface for In-Circuit-Programming (Software download)
- 8 inputs and 8 outputs, always 1 input and 1 output onboard connected
- UEA.1: lowside switching inputs and outputs
- UEA.2: lowside switching inputs and outputs
- Even if always 1 input and 1 output are connected together the may be used for different
functions at the same time, because every active output is switched off every 9ms for 3ms (pulsed
output) to enable reading of the input in this time.
Example: Input used as car call, output used as level indicator

Appendix 1.6 Module PMA

XJ1
LED
Pin1
XP2
XP3
Pin1
Hardware Version 1.0
Position Pin Function
XP1 1 +24V
2 0(24V)
3 CAN+
XP4
Pin1
XJ3
XP1
XJ2
Pin1
+24V Power supply input
0V Power supply input
CAN-Bus – High signal
XJ1
LED
Pin1 XP2
XP3
Pin1
Pin1
Hardware Version 2.1
XP4
XJ3
Pin1
XJ2
XP1