Intec MLC 8000 Operating Manual page 133

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
- Bolt in
Holded
- Test on
- Test in
- Test out
- Test Stop
- Test up
- Test down
OP device - Out
- In
Right
Ramp
Slick test
Brake/valve - Brake 1
- Brake 2
- Brake 3
Brake warning
- Up valve
- Down valve 1
- Down valve 2
- Emerg.valve
Pressure - Minpressure
- Maxpressure
Temp. - Overtemp.1
- Overtemp.2
Floor Doors
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
133/196
Description
With setting of "Signal no." up to 4 independend switches may be connected to
the lift controller.
Signal that lift is in holding position.
Control signals to check the functionality of the holding device.
- Test on:Activate test mode
- Test in: Move holding device in
- Test out: Move holding device of
- Test Stop: Stops all movement of holding device immediately
- Test up: Moves lift upwards with speed vAh
- Test down: Moves lift downwards with speed vAs
Limit switch on load derrick of a hospital operation lift mit automatic loading /
unloading.
Contact on rotary table of a hospital operation lift mit automatic loading /
unloading.
Contac on load interlock of a hospital operation lift mit automatic loading /
unloading.
Pulse count input for slick monitoring (2. position sensor on car; sometimes
necessary on lifts without machine room).
Supervision input for motor brake
Warning contact for wear of motor brake
Supervision contact for hydraulic valves
Hydraulic pressure signal
Note: Not the same function like overload input!
Temperature sensor, mainly used for motor or oil temperature supervision.