Intec MLC 8000 Operating Manual page 161

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Position Function
R1 Potentiometer (variable resistor) for display contrast
S1 Reset button
U1 EEPROM for actual parameter set
U2 Backup-EEPROM
I67 Temperature sensor (only hardware version 1.5)
LED1 Status LED for 5V controller power supply
LED2 LED "Software is running"
LED3 Fault LED (lift controller fault)
LED4 Maintenance LED (Maintenance necessary)
RS232 Serial interface
USB USB interface to PC (only hardware version 1.5)
XH1 SGO
SGM
SGU
+Bu
SGM
+24A
L
M
0(24V)
NR
XH2 Connector for telephone or Ethernet cable (depending on used module)
XH3 BR
U2
MAX
U1
MIN
XH4 +24A
A
/A
/B
B
0(24V)
XH5 +24VS
0(24V)
0(24V)
CL-
CL+
XH6 +24A
0(24V)
CH+
CH-
XH9 0(24V)
CH-
CH+
XH10 0(24V)
Not used
Input door zone switch SGM
Not used
Battery buffered 24V power supply with integrated series resistor (2kΩ) for
connecting an LED as flush signal
Door zone switch SGM (pin for connecting a flush signal)
Battery buffered 24V power supply
Not used
Not used
0V – power supply
Alarm call input (low aktiv); directly connected to alarm relay KH31
Input E1, Low active (24V DC); Function free programmable; mainly used for
connection of brake supervision contact
Input E2, for connecting PTC (motor temperature); Input is set if value of PTC
< 1.5kΩ. Function free programmable; Input can be used as digital input.
Input E3, Low active (24V DC); Function free programmable; mainly used for
connection of max. pressure contact.
Input E4, for connecting PTC (motor temperature); Input is set if value of PTC
< 1.5kΩ. Function free programmable; Input can be used as digital input.
Input E5, Low active (24V DC); Function free programmable; mainly used for
connection of min. pressure contact.
Battery buffered 24V power supply for encoder
Encoder Channel A; 5...12V oder 15..30V (siehe Jumper XHJ2+3)
Encoder Channel /A (inverted); 5...12V or 15..30V (see Jumper XHJ2+3)
Encoder Channel /B (inverted); 5...12V or 15..30V (see Jumper XHJ2+3)
Encoder Channel B; 5...12V oder 15..30V (siehe Jumper XHJ2+3)
0V – power supply for encoder
0V – power supply for shaft bus; decoupled by diode for power supply in lift
groups
0V – power supply for shaft bus
0V – power supply for shield CAN bus cable (shaft bus)
Shaft bus (CAN Bus 2) – Low-Signal
Shaft bus (CAN Bus 2) – High-Signal
Connector for handheld terminal (battery buffered 24V power supply)
Connector for handheld terminal (0V power supply)
Connector for handheld terminal (Control bus High-Signal)
Connector for handheld terminal (Control bus Low-Signal)
0V – power supply for shield CAN bus cable (control bus)
Control bus (CAN Bus 1) – Low-Signal
Control bus (CAN Bus 1) – High-Signal
0V – power supply for emergency recall operation