Intec MLC 8000 Operating Manual page 48

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level 3. Menu level 4. Menu level
LC config.2
1. Floor
2. Floor
...
CC config.2
1. Floor
2. Floor
...
LC-config.3
...
...
En/Disable calls
Disable
Enable
Autom.CC
Autom.LC
Clear Call
Priority
48/196
Description
Enabled doors and floors for landing calls if call configuration 2 is
active
Enabled doors in floor 1
Enabled doors in floor 2
Enabled doors and floors for car calls if call configuration 2 is active
Enabled doors in floor 1
Enabled doors in floor 2
Enabled doors and floors for landing calls if call configuration 3 is
active
Parameters for enabling / disabling doors and floors
normal: When an input is activated for disabling of calls or doors, then
only "normal" calls are affected
+special: Through an active input for disabling of doors or calls both
"normal" calls and special calls are affected
normal: When an input is activated for enabling of calls or doors, then
only "normal" calls are affected
+special: Through an active input for enabling of doors or calls both
"normal" calls and special calls are affected
yes: If an input is activated to enable a car call for a floor or door, then
a car call for the appropriate floor and door is automatically set in this
moment.
yes: If an input is activated to enable a landing call for a floor or door,
then this landing call is automatically set in this moment.
yes: When setting an input for disabling a car call, an already existing
car call for this floor is cleared.
Disable: If for one call, at the same time, an input was given to enable
this call and an input to disable this call, then the disable input has
priority .
Enable: If for one call, at the same time, an input was given to enable
this call and an input to disable this call, then the enable input has