Intec MLC 8000 Operating Manual page 38

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level 3. Menu level 4. Menu level
Vis.requ.[s]
Lift empty
Visitor floors
Floor 1
Floor 2
....
Handicapt people
Call type
38/196
Description
Duration of signalling a visitor request (see "Visitor floors" below)
Yes: For visitor call type 2 and 4 (landing call ist set automatic) the lift
controlle disables all car calls, but already stored car call are still
handled. If all car calls are served and the lift is empty (if sensor "Car
empty" exists), the lift serves the visitor call.
Landing calls are disabled during this time, but will not be served
before the visitor call is handled completely.
Floors (or doors), which can only be approached through a special
visitor control (so called attica or penthouse control).
Short description of the visitor control: If in the car panel a car call
button is pressed to a visitor floor, a signal (visitor request) is set for
an adjustable time. If the home owner presses an enable button (Input
function "Vis.CC enable"), the pressed car call will be acknowledged
by a flashing lamp. To set the car call the visitor has to press the car
call again (while the lamp is flashing). Once this is done, the
acknowledgement lamp lights up continuously and the lift will go
nonstop to the called floor.
Doors in floor 1 which only may be called by a visitor call (see above)
See above
Call type, which is processed as handicapt call (landing call Type 1
Type or landing call Type 2)
If the relevant landing call (type 1 or type 2, according to this
parameter) is activated in a floor, the lift drives to this floor according
to the landing call processing. While arriving the floor where the
handicapt call was activated the voice output is activated. Upon
activation of any car call, the destination floor is announced, also
speech signals for "door is opening", "door is closing" and the current
direction of travel ("lift going up-/downwards"). The waiting time until
door closing starts is extended accordingly (see parameter below). If
more car calls were given when leaving the station, they are also
announced by the voice output. Car calls that were given after the
floor status changes are no longer announced. The voice output and
increased door open time remain active until all car calls that were
pressed after the handicapt call are handled. After that, the handicapt
function is off until a new handicapt call is activated.