Intec MLC 8000 Operating Manual page 140

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
HSE-Temp.max
HSE-Temp.min
Drive error
Min.pressure
Max.pressure
Trip time
Overspeed
Light screen
Door rev.inp.
Brake check
Saf.beam err.
Car light
Maint.interv
Maint.warn.
Attend.funct. Car attend.
LC bypass
Fire control Fire state
Fire service
Fire call
Fire alarm
Evac.floor
UPS Evacuat. Evacuation
Evac.ready
Brake release
Floor Doors
- -
- -
- -
- -
- -
- -
- -
- Doors
- Doors
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
140/196
Description
Fault signal: HSE temperatur too high (Sensor on HSE)
Fault signal: HSE temperatur too low (Sensor on HSE)
Fault signal: Drive error (fault signal from drive)
Fault signal: Hydraulic pressure too low
Fault signal: Hydraulic pressure too high
Fault signal: Trip time exceeded
Fault signal: Overspeed
Fault signal: Light screen alway interrupted
Fault signal: permanent door blocking (door reverse input)
Fault signal: Brake monitoring
Fault signal: Safety beam interrupted
Fault signal: Car light off
Fault signal: Maintenance interval expired
Fault signal: Maintenance required
Attendant mode activated by input
Output for signaling that landing calls are ignored temporarely in
attendance mode (car is full)
Fire alarm active (Firemen call or Firemen trip)
Firemen trip active
Firemen call active (Trip to Fire alarm floor)
Fire alarm active
Fire alarm evacuation floor reached
Evacuation mode active
Evacuation floor reached
Output for so-called "stutter braking" for emergency evacuation: If
for the emergency evacuation the mechanical brake is opened only
via push button, this output switches when presetting speedis
reached (see "General param." - "v Brake."). The brake closes