Intec MLC 8000 Operating Manual page 53

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
1. Menu level 2. Menu level
Telecommunicat.
3. Menu level
Onboard module
4. Menu level
controller stores simultaneously. If the maximum number is reached,
The setting of this parameter should correspond approximately to the
f the number of car calls is set to 1 (see above), then here can be set
Canc.CC Max=1
Max.CC empty
After this number of trips, where the light screen was not interrupted
Check LS
Counter call
opposite to the current direction of travel, then this landing call is also
cleared if a new car call is operated in this direction (the person who
no: Only the landing call in the actual travel direction is cleared; the lift
will come back to this floor later to handle the landing call in opposite
yes: As soon as the lift reaches the bottom or top floor and changes
Clr.last fl.
Clr.opp.dir.
Specifies whether car calls are also handled if no door for this car call
CC no door
is specified (lift then moves to the floor, but do not open any doors).
LC no door
landing call is specified (lift then moves to the floor, but do not open
Delay 2.LC[s]
calls (up / down) is operated, the landing call in the opposite direction
53/196
Description
new car calls are ignored.
maximum number of persons of the car.
If a value of 0 is set, the number of internal calls is not limited.
what will happen when a new car call is pressed:
yes: An existing car call is cleared and the new car call is set
no: A new car call is ignored if a car call is already stored
Max. Number of car calls in an empty car. This feature requires a
corresponding load measuring contact.
If the value of 0 is set, the number of car calls is not limited in an
empty car.
in a floor (that means., no persons entered or got off), all other car
calls are cleared.
Only relevant for direction pending landing calls (up / down):
yes: if a lift arrives a floor, at which also a landing call was pressed
had given these landing call, entered as well).
direction.
direction, all calls are cleared.
yes: All car calls opposite to the current direction of travel will be
cleared or ignored.
Specifies whether landing calls are also handled if no door for this
any doors).
Misuse detection ina two-button control: If one of the two landing
is disabled until the expiry of this time period.
Parameters for Telecommunication
Parameters for the onboard module (Modem, Ethernet, ...)