Intec MLC 8000 Operating Manual page 131

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
Setup trip - On
- Up
- Down
- Fast
Insp.pit - On
- Up
- Down
- Slow
Ramp drive - On
- Up
- Down
Deadman On
Enable
Up
Down
Move
Car sensor - Door 1
- Door 2
- Door 3
- Middle
Drive Contact.sup.
Fault signal
Floor Doors
- -
- -
Floor Doors
- -
- -
- -
- -
Floor -
- -
- -
Signal no. -
131/196
Description
Control signals for setup trip.
In setup trip the lift is running with vRL or VR (if fast button is operated).
Control inputs for inspection control in shaft pit.
If no slow input is programmed the lift always runs with normal inspection speed
vL (see parameter "Speed signals") in inspection mode; only in final floors the
speed is reduced to vIL.
Control signals for ramp drive according to EN-81.
The ramp drive control signals are only working if the lift is located in the
assigned floor.
For more settings see „Special param." -> „Ramp drive"
Input for deadman control.
Deadman control may be activated by this input or by the parameter
„Deadman control" (see „General paramet.")
Enabling deadman control
Upward button for deadman control
Downward button for deadman control
Instead of upward and downward button a single button "Move" may be used. If
this button is pressed the lift will go to into the direction of the next car call. By a
2 floor lift the lift will go to the other floor. If "Floor" is defined (not 0) the lift will
go to the specified floor.
Sensor inputs for the position of a vehicle inside the car
The lift only starts a trip if only the middle sensor is activa
Signal input for contactor supervision
Fault signal of the drive (VVVF, hydraulic valve control board, softstarter, ...)
With setting of "Signal no." it is possible to connect more than 1 fault signal to
the lift controller (e.g. hydraulic lift with fault signal from VVVF for pump and
valve control board).