Intec MLC 8000 Operating Manual page 174

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Position Terminal no.
Description
4 EAF11
5 EAF12
6 EAF13
7 EAF14
8 EAF15
9 EAF16
10 +24A
11 +24V
12 GND
13 +24V
14 NL
15 +24A
16 M
17 L
18 CH+
19 CH-
20 GND
XF21 Connector for Software download
XF22 Modul 1
XF23 Modul 2
LED
Technical specifications:
Temperature range:
Max. power consumption by 24V:
Max. input current 24V inputs:
Max. current KF1 to KF7:
Max. output current A9-16
Max. input current 230V DC input(car light):
Mechanical dimensions:
Characteristics and features:
The module FVE is designed as an intelligent distribution board for use on the car roof or in the car
operation panel COP. However, in opposite to FVE version 1.1 and 2.1, there are no connectors for
safety circuit, earth connection, power supply etc. onboard.
- PIC18-Microcontroller with integrated Flash memory (32kByte), RAM (1536 Byte) and EEPROM
(256 Byte)
- integrated CAN bus controller
- CAN interface with high speed driver according to ISO11898 with galvanic isolation
Function
Battery buffered +24V power supply, flat cable to TVE
+24V power supply, flat cable to TVE
0V power supply, flat cable to TVE
+24V power supply, flat cable to TVE
Emergency light car operation panel COP (Output A7), flat cable to TVE
Battery buffered +24V power supply, flat cable to TVE
Intercom microphone, flat cable to TVE
Intercom loudspeaker, flat cable to TVE
Control bus (CAN Bus 1) – High signal, flat cable to TVE
Control bus (CAN Bus 1) – Low signal, flat cable to TVE
0V power supply, flat cable to TVE
Slot 1 for connecting a UEA to power supply and CAN bus
For configuration see description of Jumper XFJ1
Slot 1 for connecting a UEA to power supply and CAN bus
For configuration see description of Jumper XFJ2
LED "Software is running"
0°C to +60°C
<200mA @ 25°C (all relays and in-/outputs active)
10mA @ 25°C / Input
8A/250V AC / Relay
500mA @ 25°C / Output
10mA @ 25°C, 230VAC, 50Hz
Length:
Width:
Height:
230mm
135mm
ca. 40mm