Travel Commands And Door Commands Via Keypad (Hse Or Handheld Terminal); Travel Commands - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
5. Travel commands and Door commands via keypad (HSE or
handheld terminal)

5.1 Travel commands

Using the keypad of the HSE or hand-held terminal travel movements of the lift can be
performed (similar to the emergency recall operation). However,during these movements the
safety circuit is not affected and must be completely closed.
If the menu "travel commands" is started as the lift moves, then an emergency stop is carried
out first.
While the menu "traveling motion" is active, all other movements (also emergency recall
operation and inspection control) are disabled.
The following commands can be set:
'1': Movement in upward direction with fast emergency recall operation speed vR
'3': Movement in downward direction with fast emergency recall operation speed vR
'4': Movement in upward direction with slow (normal) emergency recall operation speed vRS
'6': Movement in downward direction with slow (normal) emerg. recall operation speed vRS
The lift moves as long as the corresponding key is pressed. When releasing the button, the
lift stops.
At movements using the keypad , the lift does not stop independently (unless the safety
circuit is interrupted). It is thus e.g. possible to drive via keyboard the lift up to the limit switch.
If at the start of the menu item "travel commands" the doors are open, then the door will be
closed first when a key is pressed ('1' '3' '4' or '6'). Are the doors closed and the key is still
pressed, then the lift starts the travel movement.
If the handheld terminal is disconnected while the menu item "travel commands" is activated,
the lift does not automatically return to normal operation. The handheld terminal must then
be re-connected and the menu item "travel commands" must be closed (it is, of course, also
possible to closed the menu directly on the HSE).
Error messages in the " Travel commands" menu
If no movements can be performed with the keyboard by any lift controller error, then the
appropriate error message is displayed on the bottom line of the LCD display:
- " Safety line off":
- "CAN-Error Drive":
- "Brake error":
- "Timeout Stopping": Problem beim Anhalten: Antrieb gibt kein Signal dass Aufzug steht
- "Contactor error":
- "Drive error":
Safety circuit is not closed
CAN bus connection to the drive disturbed
Motor brake is not opened or closed
Travel contactors not energized or de-energized
Error message from drive (e.g. VVVF)
109/196