Intec MLC 8000 Operating Manual page 139

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
LC request
Drive off
Door off
Hazard mode
Hazard call
Saf.geartest
v limit
Teach-in
Group off
Cooling
Error outputs Fault signal
Safety modul
Safety circ.
Door error
Overtemp.1
Overtemp.2
Roomtemp.max
Roomtemp.min
Floor Doors
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- Doors
- -
- -
- -
- -
139/196
Description
Output is activated if lift is moving or door is opened in a floor.
Output is activated for 1s if a landing call is pressed, while this call
is disabled by any special function.
If the lift is not used for a longer timer (see Parameter „Energy
savings" -> „Drive off[s]") the drive (e.g. VVVF) may be switched to
standby with this output.
In standby mode the fault signal from the drive is ignored.
Note: The drive should be equipped with a standby input for this
function. However, it is also possible to use this output to switch
off the power supply of the drive.
Output to switch off the door controller if the lift is not used for a
longer time and the doors are closed (see Parameter "Energy
savings"-> "Door off[s]")
Output for signaling a „Hazard transport" (Input „Hazard run"
active)
Output for signaling that a hazard call was pressed.9999
Output for automated testing the safety gear (see menu item
"Technical check")
Programmed speed limit exceeded (see "Special param. -
Deceler.check")
Teach in mode activ
Output for signaling that group control is deactivated
Output for cooling (e.g. control cabinet fan); switched by
temperature sensor on HSE (from hardware version 1.05)
General fault output
Fault signal: Error in safety unit
Fault signal: Safety circuit errornous opened
Fault signal: Door error
Fault signal: Motor overheated (input overtemperature 1
Fault signal: Motor overheated (input overtemperature 2
Fault signal: Machine room temperature too high
Fault signal: Machine room temperature too low