Intec MLC 8000 Operating Manual page 137

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
Remote off
Switched off
Overload
Full load
Occupied
Hallcalls off
Door op.push
Door cl.push
Dr.stop push
Door closing
Door opening
Saf.beamreset
SL bypass
Level zone
Level
Floor Doors
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- Doors
- -
- -
- -
- -
137/196
Description
Output is activated, if lift is switched of with input function "Remote
off" (see above).
Output is activated if lift reached the remote off floor (see input
function "Remote off" above).
Overload indication
Full load indication
Output,that lift is occupied; output is set if at least 1 call is set or, if
exist, the revolving door is opened.
Output is set, if landing calls are disabled
For fireman lifts: If in fireman mode the doors don't open
automatically (only by pressing the door open push), than this
output is activated if the door open push is active (acknowledement
lamp inside door open push).
See also „Special para." -> „Firemen run"
For fireman lifts: If in fireman mode the doors don't close
automatically (only by pressing the door close push), than this
output is activated if the door close push is active
(acknowledement lamp inside door close push).
See also „Special para." -> „Firemen run"
Acknowledgement lamp inside door stop push
Output is set if doors are closing
Output is set if doors are opening
Output to reset a safety beam after interrupting the safety beam
while lift is moving.
The output is only set after a new car call is pressed. The output is
then pulsed at intervals of 2s until the light curtain is really
resetted.
Safety circuit car or shaft door shorted (according to EN81-20)
Output for switching a flush display if it can not be switched
directly by a magnetic switch. Output is active when the lift is
inside the door zone.
Output is set if lift is in level.