Intec MLC 8000 Operating Manual page 186

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
JP1 Jumper for CAN bus terminator (CAN bus to shaft)
→ Jumper must be set if CBK is located at the end of the CAN bus cable (shaft bus).
JP2 Jumper for CAN bus terminator (CAN bus to HSE)
→ Jumper must be set if CBK is located at the end of the CAN bus cable.
SW1 DIP switches for setting CBK address
DIP4 DIP3
Off Off
Off Off
Off Off
Off Off
Off On
Off On
Off On
Off On
On
LED1 LED "Software is running"
LED2 Message transmission on CAN-Bus to HSE
LED3 Message receiving on CAN-Bus to HSE
LED4 Message transmission on CAN-Bus to shaft
LED5 Message receiving on CAN-Bus to shaft
Technical specifications:
Temperature range:
Power supply:
Current consumption:
Mechanical dimensions:
Characteristics and features:
- Physical segmentation and amplification of CAN bus signal
- Extension of possible number of bus nodes on shaft bus up to 512
- PCB in DIN rail housing
- dsPIC33 microcontroller with internal Flash (64kByte) and RAM (16 kByte)
- 2 integrated CAN-Controller
- 2 CAN bus interfaces with high speed driver according to ISO11898 with galvanic isolation
- ICSP interface for In-Circuit-Programming (Software download)
DIP2 DIP1
Off Off
Off On
On Off
On On
Off Off
Off On
On Off
On On
X X X
0°C to +60°C
24V DC
ca. 110mA @ 25°C
Length: 80mm
Width: 70mm
Height: ca. 35mm (without connectors)
CBK1 (Branch 1)
CBK2 (Branch 2)
CBK3 (Branch 3)
CBK4 (Branch 4)
CBK5 (Branch 5)
CBK6 (Branch 6)
CBK7 (Branch 7)
CBK8 (Branch 8)
CBK as Amplifier (e.g. on control bus)