Introduction; Operation Of The Lift Controller Mlc 8000 And Parameter Input - Intec MLC 8000 Operating Manual

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0

1. Introduction

1.1 Operation of the Lift Controller MLC 8000 and Parameter Input

The operation of the lift controller MLC 8000 can be handled either from the keypad and LCD
display located on the HSE, or with a mobile handheld terminal DSE.
HSE and handheld terminal have an LCD display with 16 * 4 characters and a keypad using
the following keys:
- Number keys 0 to 9
- Cursor keys ↑ and ↓
- ENTER key ↵
- ESC key
The handling of the HSE and the handheld terminal is very simple. With the cursor keys ↑
and ↓ a menu item in the LCD display can be selected. Pressing ENTER ↵ the selected
menu item starts. Either a function is activated or a submenu is called.
With the ESC key a function may be terminated or you can leave a submenu.
The entire menu structure is described in more detail in the section "Menu structure".
The handheld terminal DSE is connected via the CAN bus to the lift controller and can be
inserted and withdrawn during operation. Currently located on both the HSE and on the FVE
appropriate connectors. Additionally, it is possible to insert at any point corresponding
adapters on both the control bus and on the shaft bus.
After connecting the hand-held terminal to the lift controller first following display appears
(example):
If the handheld terminal was connected to the control bus (e.g. FVE), then only the number 1
is displayed on the bottom line. Pressing ENTER ↵ the connection is made to the lift
controller. Further operation of the hand-held terminal is then identical to the operation of the
HSE.
If the hand-held terminal was connected into the shaft bus of an lift group, then the group
numbers of all HSE modules will appear within the group. By pressing the corresponding
number button it can be selected, with which lift of the group the connection has to be done
(by pressing ENTER ↵ always the lift 1 is selected).
If, after you connect the handheld terminal, in the bottom line no number appears, then the
CAN data transmission between handheld terminal and lift controller is disturbed.
If the CAN connection gets disturbed while working with the handheld terminal, then following
display appears on the LCD screen of the handheld terminal :
** INTEC GmbH **
Lift controller
Connect to HSE
1 2 3
11/196