Intec MLC 8000 Operating Manual page 143

INTEC GmbH
Lift controller MLC 8000
22/12/2016
Operating manual V2.0
Main function Sub function/
Direction/
Floor
Direction dn
Car call
Door closing
Door opening
Enable
Clock run 1
Clock run 2
Fire state
Fire service
Fire call
Fire alarm
Evac.active
Special mode
Special run
VIP run
Emerg. run
Fault signal
Out of work
Use card
Speech Level Ansteuerart:
- 1 of n
- Binary
- Gray code
Floor Doors
- -
Floor
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
Signal no. Offset
143/196
Description
every change to upward direction).
See above; for downward direction
Signal for speech unit that car call for "floor" pressed
Signal for speech unit if the door starts closing.
With door parameter „Cls.delay[s]" a delay time between the
speech message and door closing may be set.
Signal for speech unit that door starts opening.
Enable signal for speech unit for actual floor information.
As floor signals the output function „Speech level" is used.
Signal for speech unit that clock run 1 is enabled.
Signal for speech unit that clock run 2 is enabled.
Signal for speech unit that Firemen mode is activated.
Signal for speech unit that Firemen run is activated.
Signal for speech unit that Firemen call is activated.
Signal for speech unit that Fire alarm is activated.
Signal ffor speech unit that Evacuation run is started.
Signal for speech unit that Special mode is activated.
Signal for speech unit that Special trip is activated.
Signal for speech unit that VIP trip is activated.
Signal for speech unit that Emergency trip is activated.
Signal for speech unit that fault condition is entered.
Signal for speech unit that lift goes out of operation.
Signal for speech unit that a temporarely disabled car call was
pressed.
Level information for speech unit.
See also output function "Level display" above.
The floor level anouncement is started by the "Enable" signal (see
above).
See also "Special param. - Speech unit"