Acquire:ccdf:trace{1|4}[:State] <Boolean - Keysight 8990B Programming Manual

ACQuire:CCDF:TRACe{1|4}[:STATe] <boolean>
This command sets the state of the CCDF trace from channel 1 or 4.
Syntax
ACQ
Example
ACQ:CCDF:TRAC1 ON
Remarks
– This command is only applicable for channels 1 and 4. If you send this
– This command is only applicable in the CCDF acquisition mode. If the
Reset condition
On reset, the CCDF trace from both channels 1 and 4 is turned on.
Keysight 8990B Programming Guide
:CCDF :TRAC
command for a channel other than 1 or 4, error 700,"Applicable to channel 1
and 4 only" will occur.
acquisition mode is not set to CCDF, error –221,"Settings conflict;Requires
CCDF mode to be enabled" will occur. Refer to
<character_data>" on page 132 to set the acquisition mode.
1
:STAT
4
This command turns on the CCDF trace from
channel 1.
ACQuire Subsystem
Space
0|OFF
1|ON
?
"ACQuire:MODE
4
125