Configuring A Cw Signal With The R&S Sgs100A Web-Gui - R&S SGS100A Getting Started

®
R&S SGS100A
6. Select "SGMA-GUI > RF On" to enable the output of the CW signal.
The 5 GHz signal is output at the [RF OUT] connector at the rear panel of the
R&S SGS.
Identifying a specific instrument
If several instruments are active in the R&S SGMA-GUI, use one of the
device identification functions to identify a specific device:
● Select "SGMA-GUI > Instrument Name > Setup > Remote > Remote
Channels > Device Identify". The green [LAN] LED on the front panel of
the instrument blinks.
● Press the [ID] key on the instrument's front panel. The "Edit Instrument"
dialog of the respective instrument opens.
4.2 Configuring a CW Signal with the R&S SGS100A
Web-GUI
The R&S SGS100A Web-GUI is an alternative way to operate the R&S SGS.
There is no installation needed. It can be used with all devices and operating sys-
tems, including tablets and smart phones, which have one of the following web
browsers installed:
● Mozilla Firefox
● Google Chrome
Getting Started 1416.0570.02 ─ 11
Configuring a CW Signal with the R&S SGS100A Web-GUI
First Steps with the Instrument
34