Left Balancer Needle Bearing - Honda 2010 CRF250R Service Manual

CRANKCASE/CRANKSHAFT/TRANSMISSION/BALANCER
LEFT BALANCER NEEDLE BEARING
Remove the balancer shaft (page 12-9).
Remove the snap ring , oil pump driven gear and drive
pin.
Remove the snap ring and left needle bearing
Dn've in a new Drive in a new balancer shaft needle bearing using the
bearing squarely
special tools.
with the marked
side facing up.
TOOLS :
12-12
Driver
Attachment, 32 x 35 mm
Pilot, 20 mm
07749-0010000
07746-0010100
07746-0040500
After installation, apply engine oil to the bearing.
Install the snap ring into Ihe groove in the left
crankcase.