Rear Brake Caliper - Honda INTERCEPTOR 2002 Service Manual

LEFT CALIPER INSTALLATION
Install the left brake caliper onto the bracket.
Install the left brake cal iper/b racket assembly over
the brake disc.
Insta ll the new caliper pivot bolt and secondary
master cylinder joint bolt.
Tighten the bolts to the specified torque.
TORQUE:
Pivot bolt: 31 N ·m (3.2 kgf·m, 23 lbf.ft)
Joint bolt: 31 N ·m (3.2 kgf·m, 23 lbf.ft)
Insta ll the brake hose eyelet joints to the caliper
body with new sealing washers and oil bolts.
Push the brake hose eyelet to the stopper o n the cal-
iper, then tighten the oil bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf.ft)
Install the brake pads (page
15-17).
Fill and bleed the front brake hydraulic system
(page 15-7).
REAR BRAKE CALIPER
REMOVAL
Remove the rear w heel (page
14-5).
Drain t he rear brake hydraulic system (page 15-7).
Avoid spilling fluid
Remove the oil bolts, sealing washers and brake
on painted, plastic,
hose eyelet joints.
or rubber parts.
Place a shop towel
over these parts
whenever the sys-
tem is serviced.
HYDRAULIC BRAKE
15-41